With this small plug and play electronic module you can have the "Burst" function on your replica (controlled bursts ranging from 1 to 12 shots can be programmed).
Easy to program and install, it does not require welding or special attention, it can be installed directly on the connector between the battery and the replica!
Brand: Swiss Arms
Product: Electronic fire programmer

Technical specifications:

- Connects directly between the battery and replica, no changes needed, no soldering, no replacement.
- Programming memory: once programmed, the next time it is used it will remember the set program.
- Dimensions: 55x18x10 mm
- Operating voltage: between 7.2 and 12 v
- Maximum operating voltage: 65 Amps
- Operating temperature between -10 ° / 70 °
- Recommended battery type: NiMH (from 8.4 to 12 v), Li-Po from 2 to 3 cells (7.4 v and 11.1 v)
- BURST (controlled burst) programmable from 1 to 12 shots.
- FULL AUTO mode up to 30 shots
- Automatic detection of the minimum voltage according to the type of battery selected to avoid battery deterioration (useful when using LiPo batteries)