Professionally made MOSFET for airsoft electric guns
The device increases the rate of fire of the replica and the battery lasts longer than when used with standard wiring

Technical specifications:

• very small device, fits almost anywhere
• pre-soldered cables allow for quicker and easier installation in the replica, the harness is long enough for all types of weapons. Just cut the cables to the required length and connect the connectors (included in the package)
• 2 high quality 1,5 qmm (awg16) black wires with mppe insulation, length 500mm each, are pre-soldered on the devices. The blue wire 0.34mm2 (awg22) with a length of 1000mm is used for connection at any point of the red wire
• a 1000mm 1,5qmm (awg16) red wire with mppe insulation is included in the package
• board covered with protective coating, protects the device from water
• if you want to use your own cables, choose the device without wiring
• designed for springs up to m160 (equivalent for 75a single shot current or 25a burst fire for max. 30 seconds). For higher load please use mosfet ii (jt-mos-w2)
• designed for standard batteries up to 17v (ni-xx 8.4 - 12v, lipol 7.4 - 14.8v)
• 5-wire connection
• the positive lead is not connected to the device
• device size 15mm x 7mm x 5mm
• no power consumption in idle mode
• no spark on the switch contacts
• in full-auto mode, the piston stops in a random position thanks to the mechabox design
• for correct operation it is necessary to have a cut off lever, selector plate, anti-reversal, trigger and trigger lock, as in a standard gearbox

• device with wiring
• male deant connector
• 30a mini fuse
• 4x 2.8mm female faston
• 6x black heat shrink tube 3,2mm - length 20mm
• 3x black heat shrink tube 4,8mm - length 20mm
• English installation manual